Yes – our emcoround products have been tested in wet areas at 50°C heat and a relative humidity of 100%. The products are approved for applications in wet areas.

Ceramic, natural and artificial stone, steel, stainless steel, aluminium, brass, copper, painted and coated surfaces, glass, mirror, etc.

The 2-component adhesive takes 4 hours to set. During this time, no load must be placed on the accessory. You can also watch our installation video about this. Watch the video here.

Before an accessory is approved for gluing, we carry out stress tests in the laboratory. The glued accessories are loaded with different weights, and the weight is gradually increased. Whether the accessory is suitable for gluing or has to be...

The accessory can be freely adjusted on its mounting plate.

It is possible to glue onto joints, but we recommend not doing so, as removing residues from joints is more labour intensive. If you do still need to do this, single horizontal or vertical joints are more suitable than crossing points.

Yes, you can, if the drill holes are vacuumed out and filled with adhesive before the mounting plate is attached.

The adhesive is resistant to standard household cleaning agents if used correctly.

Once the glue has set, it behaves like a rubbery plastic. The long-term stability has been tested extensively – even in wet areas. The adhesive bond will last until you decide to remove it.  

On a smooth surface, you can simply remove a mounting with a putty knife and a hammer. Should any traces of adhesive remain, they can easily be removed with a ceramic scraper or a silicone remover and a cloth. You can also watch the i.Glue...

You can attach 5–6 accessories with one pack.

We are continuing to work closely with i.Glue Systems to further develop the adhesive system in line with the market and to offer further solutions.

Our partner regularly tests the adhesives and confirms that, under real conditions in northern Europe, the glue can be stored for more than two years without any reduction in its adhesive effect. Testing is currently under way on storage under...

The system consists of a holding ring, a cleaning cloth, an abrasive pad, a glue sachet and application instructions.

The adhesive can be handled at temperatures of up to 50°C without any problems. The handling time is reduced from 15–20 minutes under conditions such as those in northern Europe to 2–2.5 minutes under the above-mentioned conditions.

Our new emcoround series of accessories already comes with the emco glue system. Click here to go to the product page. To the product page

The setting time was calculated at standard climate (23°C, 50% humidity) plus a safety margin. Temperature and humidity affect the setting time.

The glue is EU-REACH compliant and is not labelled as hazardous material. Since it only shrinks slightly during hardening, it is also very mould resistant.